Cement Retained Provide® Abutment Indirect Technique
Non-Prepared Post
(continued from previous page)

Laboratory Procedure
10. Use the appropriate, color-coded Provide Analog that matches the impression coping. Line up the flat side of the analog post with the flat in the impression coping. Then, insert the Provide Analog into the Provide Impression Coping until it snaps over the margin. Pour the cast in stone using a soft tissue material around the analog. Articulate with the opposing cast.

11. Block out the dimple on the top of the Provide Abutment Analog with wax prior to waxing the crown coping on the Provide Waxing Sleeve. Use the corresponding sized waxing sleeve to fabricate the final PFM crown coping. Place the waxing sleeve over the post, line up the flat sides and verify it is seated to the margin. Tack the sleeve in position with wax.

12. Wax the single unit PFM crown coping to the waxing sleeve. Invest, burnout and cast the coping in a semiprecious or high noble alloy.

(continued on next page)