Home
Cadastre-se
 
 
Produtos
Educação
Biblioteca Multimídia
Corporativo
 
 

Cement Retained
Provide® Abutment
Indirect Technique
Prepared Post
(continued from previous page)

Laboratory Procedure
11. Insert the appropriate Provide Laboratory Analog with pin (PAAP48 or PAAP65) collar into the Provide Impression Coping With Holes and snap over the margin area. Cut the Provide Die Reinforcing Pin to the proper height and try in for height verification. The pin should have a minimum of 1mm clearance between the top of the pin and the impression. Pour the cast in stone, inserting the Reinforcing Pin into the Provide Analog before the stone sets.

12. Pin, section and articulate with the opposing cast.

13. Apply die spacer and wax the single unit PFM crown coping on the stone die. Invest, burnout and cast the coping in a semi-precious or high noble alloy. Opaque, build porcelain, stain and glaze the crown.

undefined

undefined

(continued on next page)

 

 

 

 

 
 
BIOMET 3i | All Rights Reserved